Dodgeit got a question for you.When I could not connect to P5 I went to portal in my mag254 and changed it to P2.When I went papio to change it there also to P2 I could not so I decided to go back into my mag and change the portal back to P5.when I unplug the power cable and plug it back in to reboot nothing is working I just get a message unsupported signal. please check the device output.I tried a reboot while holding the button with3 lines and 3 dots but that does not work. Any ideas
Announcement
Collapse
NEW NFPS WEBSITES & EMAIL
In order to serve you better we have moved our websites to the following domain names:
Papiao: https://papiao.is
NFPS Main Site: https://iptvprivateserver.is
NFPS Website Hispana: http://servidoriptvprivado.is
NFPS Foro Hispano: http://servidordeiptv.is
E-Mail: [email protected]
Papiao: https://papiao.is
NFPS Main Site: https://iptvprivateserver.is
NFPS Website Hispana: http://servidoriptvprivado.is
NFPS Foro Hispano: http://servidordeiptv.is
E-Mail: [email protected]
See more
See less
mag254 won't reboot
Collapse
X
-
I tried a reboot while holding the button with3 lines and 3 dots but that does not work. Thats making sure the remote is pointing at the stb? You can also try unplugging everything from the box.Then plug just the power back in and let it boot for a few mins. Then unplug it and plug everything back in and see if this helps you.
Comment
-
Well been at it about 4 hours now still stumped.I'm going to tell you what I screwed up and maybe somebody knows what I have to do to correct my f_ckup.I had P5 loaded in my mag 254 and then I loaded the P2 also.When I went to papiao site to change portal I could not so I decided to go back into my mag and get rid of the P2.Well low and behold I can't get my mag to work.I tried to get in Bios mode by holding the button with 3 dots and 3 lines while I pluged in the power cord no dice.Been all over the internet no luck.I know the answer is out there but so far it eludes me LOL.
Comment
-
"unsupported signal" or incompatible signal? Sounds like the message I got when the mag254 box was set to HDMI output but I was trying to view it in an old analog TV. Might take a look at your video settings on your TV/Monitor or maybe try a different HDMI cable.....Glad to hear you got back in. I don't think you'd get that yellow bar to load if the portal is down
Comment
Comment